Oliver Stoner, Руководство по эксплуатации

Страница: 16 / 25

INCREASING CAPACITY
The above discussion gives the general procedure for starting and operating an Oliver Stoner. After obtaining
satisfactory results at low capacity, increasing capacity is a relatively simple operation. Only after satisfactory
results are achieved should this be tried.
1. Increasing tilt and eccentric speed.
Begin by increasing the tilt. This will cause the material to shift toward the clean product discharge. To correct
this, increase the eccentric speed until the material is shifted back to the proper pattern. Continue increasing
tilt and eccentric speed alternately until you have the tilt at the maximum amount where you can still maintain
the correct bed depth by adjusting the eccentric control.
2. Increasing the feed rate.
Next open the feed gate slightly. This increases the feed rate and the bed depth will increase. Wait a couple
of minutes to observe the change in the material on deck. As the bed depth increases over the deck, it may
be necessary to increase the air setting slightly to compensate for the thicker bed. Continue increasing the
feed rate until you reach the maximum feed rate where you still obtain the desired separation.
-13-
return to index