Oliver 695, Руководство пользователя по эксплуатации и инструкция

Страница: 8 / 38

695 PROOFER
0695S20004 3-2
Electrical Connection
WARNING
THE PROOFER MUST BE CONNECTED TO A PROPERLY GROUNDED ELECTRICAL
SOURCE OF THE SAME RATING AS THE MACHINE. FAILURE COULD RESULT IN
AN ELECTRICAL SHOCK WHICH MAY CAUSE INJURY OR DEATH.
WARNING
ALL WIRING AND ELECTRICAL REPAIRS SHOULD BE DONE BY A QUALIFIED
ELECTRICIAN. FAILURE TO DO SO MAY CAUSE SERIOUS INJURY OR DEATH.
CAUTION
A SPECIAL HEAVY DUTY ELECTRICAL SERVICE MUST BE PROVIDED FOR SAFE
OPERATION OF THE PROOFER.
The following service requirements are recommended, dependent on the voltage of the
unit you have purchased. Your proofer’s requirements can be found on the nameplate
attached to its rear surface.
For voltages other than those shown below please contact the factory.
1 phase, 60 hz, 115VAC, 14.5 Amps.
( 20 amp Dedicated Circuit )
The proofer is shipped from the factory with a power cord. Leave at least two feet of slack
so that access can be gained to the proofers right side. This makes sliding the proofer out
for service more convenient. Whatever method is used the proofer should be wired in a
manner which would conform to the U.S. “National Electric Code”.