Oliver 4275C, Руководство пользователя

Страница: 41 / 70

4275C Jointer OLIVERMACHINERY.NET 41 | Page
Inspect Outfeed Table Parallelism
1. Disconnect the jointer from the power
source!!
2. Place a straight edge on the outfeed table in
positions as shown below:
3. Make sure the straight edge is hanging
above the cutterhead:
4. In each position, carefully rotate the
cutterhead. When the outfeed table is in
parallel with the cutterhead, cutters should
be barely scraping the straight edge when
the cutterhead rotates.
5. If the outfeed table and cutterhead are out
of alignment, move to
section “ Adjust Table
Parallelism/Coplanarity ”.
If the outfeed table is in parallel with the
cutterhead, proceed to the next
section “ Inspect
Infeed Table ”
Inspect Infeed Table
1. Disconnect the jointer from the power
source!!
2. NOTICE: Make sure the outfeed table is
properly adjusted before continue.
3. Place a straight edge that splits evenly on
both the infeed and the outfeed table.
4. Raise the infeed table so that it is at the
same height as the outfeed table. When
proper height is set, the straight edge will sit
flat and flush on the infeed and the outfeed
table. Rotate carbide cutter away if it
contacts the straight edge.
5. Move the straight edge across the tables in
positions as shown in the picture below.
Rotate carbide cutter away if it gets in the
way.
6. In each position, the straight edge should sit
flat and fit flush on both infeed and outfeed
tables.
7. If infeed/outfeed tables are out of alignment,
move to section “ Adjust Table
Parallelism/Coplanarity ”.
8. Otherwise, congratulations! The jointer
tables are well calibrated for your next
project!