Oliver 4275C, Руководство пользователя

Страница: 25 / 70

4275C Jointer OLIVERMACHINERY.NET 25 | Page
Wiring and Grounding
DANGER
Deenergize the electrical circuit before touching any enclosed, electrified parts.
Touching an electrified part WILL result in serious personal injury or death.
WARNING
All electrical work must be done by a qualified electrician and must meet the
electrical code in your area.
Make sure the voltage of your power circuit matches the power requirement of this
machine, and the circuit is sized to supply power to the jointer.
Wiring Instructions
1. Power off before connecting any wires!!
2. Remove the screw that secures the junction
box cover.
3. The wire connector inside the junction box
accepts hot conductors with ring/spade
terminals. The ground conductor can be
connected with a wire nut.
4. Insert the power cord through the strain
relief. The strain relief can be temporarily
removed from the junction box to make this
task easier.
5. The picture below shows an example of how
a single-phase 230V model can be connected
to a power source with the ring terminals
and a wire nut.
Please refer to the section “Wiring Diagram”
for connecting a specific model to a power
source.
IMPORTANT: Always refer to local electrical
code for properly connecting any machinery
to a power source.
6. Hand tighten the sealing nut of the strain
relief to keep the cord in place.
7. Re-install junction box cover.