Rail Assembly
1. Place a M8x16 carriage bolt (A, Figure 4)
through the bracket (B, Figure 4) and hold in
place with a M8 lock washer and M8 cap nut
(C, Figure 4).
Note:
Just thread the cap nut
onto carriage bolt a couple turns to hold in
place. Leaving the bolt loose will make it
easier to insert the head of carriage bolt into
guide rail slot.
2. Angle the head of carriage bolt into the
keyed slot found on the bottom of guide
tube. Slide in place to engage square
shoulder of carriage bolt with slot and
tighten cap nut.
3. Once all of the brackets have been attached
to the guide tube (D, Figure 4) mount the
brackets to table using seven M10x16 flat
head socket bolts (E, Figure 5).
4. Mount the rear rail brackets (F, Figure 6) to
the table with five M10x16 flat head socket
bolts (G, Figure 6). Leave loose at this time.
5. Mount the rear rail (H, Figure 6) to the
brackets with five M10 lock washers and five
M10x20 hex head bolts (I, Figure 6).
6. Thread two M6x10 socket head cap screws
(J, Figure 6) into the rear rail at both ends.
They act as a stop for the fence.
8