
6. Insert front fork of blade guard assembly (A,
Figure 16) through opening in the table. The
tab is held in place between the flat washer
and bracket, see Figure 16. Finger tighten
hex nut (B, Figure 16) only at this time.
7. Insert the rear fork of the blade guard
assembly (C, Figure 16) into the guard
support assembly between the flat washer
and shoulder, see Figure 16. Finger tighten
hex nut (D, Figure 16) only at this time.
8. Place a straight edge against the splitter and
blade to make sure they align, as shown in
Figure 17. If adjustment is necessary use
the provided wrench to loosen the jam nut
(E, Figure 18) on the rear fork. Thread the
guard support in, or out by turning the hex
head (F, Figure 18) to bring the splitter in
line with the blade. Repeat the same
procedure for front fork.
9. Tighten the jam nut (E, Figure 18) and
tighten the hex nut (D, Figure 16) with the
provided wrenches. Repeat the same
procedure for front fork. Recheck the splitter
alignment and adjust if necessary.
12