OLITREM Marecos Horeca ARV 36, Руководство по эксплуатации и техническому обслуживанию

Страница: 28 / 76

26
5.1. Cleaning
The equipment should be cleaned at least once a month. The following opera ons are to be carried
out:
ü Always keep the equipment free of ice. Use a so cloth or so brush to remove loose ice.
Never use sharp tools and be careful not to damage the seal. Keeping the equipment free of ice
prolongs its useful life;
ü Clean the outside and inside of the appliance with a dry, so cloth or water and a neutral
detergent solu on;
ü Clean all seals and gaskets using a damp cloth. Remove all dirt and wipe off with a dry cloth
a erwards;
ü
Do not spill water directly into the equipment. Water spills can damage insula on materials
and electrical components;
ü Remove dust from the inside of the compressor compartment using only a dry brush or
vacuum cleaner;
ü The cooling system parts of this unit are completely sealed. They do not require lubrica on.
6. REVERSING THE DIRECTION OF THE DOOR
Instruc ons applicable to models ARV 36, ARV 66, ARV 150, ARV 350, ARV 450, ACE 66, ACE 150, and
ACE 450. For other models, the change must be made at the factory.
You should disconnect the equipment from the mains. Unscrew the top cover by removing the two
screws on the front and rear. Pay a en on to the connec ons of the digital thermostat, so that they do
not become disconnected.
Remove the bo om bracket from the door and loosen the door's top spring using a star screwdriver and
an Allen key 10mm.
Remove the door and turn it 180º. Reapply the spring hinge and the bearing so that there is enough
spring pressure to close the door.
Tighten the spring on the top bracket and ghten the lower bracket. The handle should be inserted into
the exis ng holes.
Adjust the door so that it has a correct seal. Confirm that the connec ons of the digital thermostat
remain connected properly and close the top cover.
7. REPLACEMENT OF LIGHTING (Apllicable Models)
Led lights, with power equal to 12W/m. Power supply 12V DC.
This opera on must be carried out by the manufacturer, authorized representan ves, or qualifiedl
personnel in order to avoid danger.