oliser MS Soho, Руководство пользователя

Страница: 17 / 20

You may also aid the evacuation process, in part, by
using the suction pipe on the MS-Versatile.
Insert the needles into the sponges in synchronization
with correct colour matching. As per the illustration
(picture shown) the colors, from left to right, are:
YELLOW, MAGENTA and CYAN.
HP-23/25/41/78 FILLING
Place the cartridge on the right hand side of
the machine, in its correct “park” position - as
shown.
You notice the cartridge is inverted. Filling in
an upside down position (without vacuum)
has been proven to yield the most successful
results.
Push the filling START/STOP button to activate the
filling of the cartridge. Adjust the ink volume for C/M/
Y as per your own selection.
After filling is completed, remove the cartridge from
its designated park position and remove the needles
(always take care to keep needles clean – to avoid
cross-contamination)
The next function to perform is pump-priming and air
bubble air removal. This is undertaken with pump (in -
cluded) in shipments (from 1 July 2004); alternatively
it can be purchased as an optional extra.
Place the pump over ventilation holes (at bottom of
cartridge, when inverted) as shown.
This must be done for each individual colour. Push the
pump gently and attentively watch the head (nozzle
plate) for results..
If bubbles (foam) appear, this has to be removed. Clean the nozzle plate immediately and rapidly to
avoid cross-contamination. Repeat this process until clear flowing ink is achieved (no bubbles at all
must be present).
This must be repeated for each colour.
The reason we need to remove foam is so that it will not involve itself in the inkflow cycle and cause
white lines (banding) in the print.
Once you have performed this careful function on all three chambers, dab, in a downward motion the
cartridge nozzle place onto padded paper towel. Ensure that all three colors appear in a rectangular
fashion.
*** Cartridge is ready to test print ***