Olimpia splendid PELER 10 WIFI, Инструкция по эксплуатации и техническому обслуживанию

Страница: 43 / 288

PELER 10 WIFI
ENGLISH
EN - 13
To fill the tank (7) proceed as described below:
• Place your hand underneath the tank (7) in the handle (6) as shown in figure
“F”;
• withdraw the tank (7) without extracting it from the appliance;
• pour water into the compartment (7);
• replace the compartment (7) in the appliance.
• Check the water level in the tank (7) through the water level gauge (12) (fig.G).
• Do not fill the tank (7) beyond the maximum level.
• Always use clean water.
• The appliance could produce a slight smell or the water in the
tank (7) could be slightly coloured during first use; this events
are normal and absolutely harmless for the user’s health.
3.4 - INSTRUCTIONS FOR OPERATION
a.
Insert the plug in the power socket.
When the appliance is switched on for the first time, you will hear a beep
and it will go into stand-by. All buttons will be disabled, with the exception
of the ON/OFF one.
The functions can be enabled or modified either from the control panel or
from the remote control.
b.
Switch on the appliance by pressing the
ON/OFF
key (A1).
c.
Manually lift the horizontal flaps as desired.
d.
Select the desired mode.
3.4.a - ON/OFF key (A1)
When the appliance is in stand-by, all buttons are disabled, with the exception
of the ON/OFF button.
Press the key (A1) to switch on/off the appliance.
The default initial fan speed is “low” and the default operating mode is “ cooler ”;
All functions are available.
3.4.b - Cooler / humidifier key (A2)
Make sure that water is present inside the tank (7) before activating the
humidifier function.
Press the key (A2) on the panel or through the remote controller to activate the
function; the led in correspondence of the key (A2) lights up.
Press the key (A2) a second time to deactivate the function.