Olimpia splendid OS-CEBCH36EI, Инструкция по установке, использованию и техническому обслуживанию, Страница: 45 / 88

45
ENGLISH
2
2 INSTALLATION
Follow the instructions given in this manual closely in order to achieve a successful installation and optimum performance.
Failure to apply the indicated regulations, which may cause the appliance to malfunction, relieves OLIMPIA SPLENDID of any
form of warranty and of any damage caused to persons, animals or property.
The electrical system must comply with current regulations, as stated in the Technical Features chapter, and be correctly earthed.
The appliance must be installed in an accessible position to enable maintenance to be carried out.
2.1 INTERNAL UNIT INSTALLATION (fig. 4, 5, 6, 7)
Prepare:
• two 10 mm diameter bolts for fixing to the wall suitable for the type of support
• leave enough space, at least 25 cm at the sides and above, to remove the covers so that routine and special maintenance
can be carried out
• a nearby water drainage point
• compliant power supply near the internal unit
• a water supply to fill the hydraulic circuit
• communication cable between internal unit and external unit (see sect. 2.9.2)
The internal unit must be fixed to the wall at head height, inside the residence.
For the installation and positioning of piping see fig. 4 and use the template or mount on the floor on the dedicated positioning
kit B0675 supplied with the unit.
2.1.1 Removing the front panel (fig. 5)
Open the right door (fig.5 ref.A) by turning it to the right.
Unscrew the screw fastening the front panel (fig. 5 ref. B).
Lift the front panel and pull it towards you (fig. 5 ref. C).
2.1.2 Access to internal components (Figg.6, 7)
To access the components inside the electric panel, remove the two screws (fig. 6 ref. A) fastening the cover on the left-hand side.
To access the components behind the electric panel, remove the four screws (fig. 6 ref. B) and turn the panel on the hinges
located on the right-hand side of the panel. The electric panel can be detached and attached using the grooves on the right-
hand side of the panel (fig. 6); this enables access to all the components inside the appliance and the appliance to be installed
or maintained more easily.
The following components are housed inside the electric panel (fig. 7):
A Cables inlet
B Internal unit power terminal board
C Utilities terminal connections
D Cable grips
E Electrical heater elements thermomagnetic circuit breaker
F Safety contactor for electrical heater elements
G Elements relay
H EMC filter
I Control electronic board
L Fuse 250V 10A T
M DHW circuit Compressor condenser
2.2 EXTERNAL UNIT INSTALLATION (fig. 8)
Install the external unit on a solid base that is able to support its weight; if installed incompletely or onto an inappropriate base,
the external unit could cause damage to persons or property, if it should detach from the base.
It is very important that the installation place be chosen with extreme care in order to ensure adequate protection of the device
against impact or possible consequential damage.
Choose a place that is adequately ventilated and in which the outdoor temperature in summer does not exceed 46°C.
Leave sufficient free space around the appliance in order to avoid recirculation and to facilitate maintenance.
Prepare a layer of gravel underneath the appliance for drainage of the defrost water.
Leave space underneath the unit to prevent the defrost water from freezing. In normal situations, ensure the base is at least 5
cm off the ground; for use in regions with very cold winters, ensure a space of at least 15 cm on both sides of the unit.
When installed in a location with high snow fall, mount the support of the appliance at a height that is above the maximum level
of snow.
Install the unit so that wind is not blowing across it.
Prepare:
• anti-vibration dampers
• compliant power supply near the external unit