Olimpia splendid NEXYA S5 E CASSETTE, Инструкция по эксплуатации и техническому обслуживанию

Страница: 99 / 380

NEXYA S5 E
ENGLISH
EN - 43
Checks before resuming use of the air conditioner:
a. Check that the wires are not broken or disconnected.
b.
Check that the air filter is clean and installed correctly.
Clean the filters after a long period of inactivity of the air conditioner.
c. Check that the air outlet or inlet are not obstructed (especially after a long period of inactivity of the air
conditioner).
Do not touch the metal parts of the unit when removing the filter.
There is a risk of injury due to the sharp metal edges.
Do not use water to clean the internal parts of the air conditioner.
Exposure to water can ruin the isolation, with the risk of electric shocks.
When cleaning the unit, make sure the switch is off and the power supply is discon
-
nected.
9.2 - OPTIMAL OPERATION
To achieve optimal performance, please note the following:
• Adjust the direction of the air flow so that it is not blowing directly on people.
• Adjust the temperature to achieve the highest possible level of comfort. Do not adjust the unit to excessive
temperature levels.
• Close doors and windows in COOL mode or HEAT mode.
• Use the TIMER ON button on the remote controller to select a time you want to start your air conditioner.
• Do not place any object near the air inlet or air outlet, as the efficiency of the air conditioner may be re
-
duced and the air conditioner may stop running.
• Clean the air filter periodically, otherwise cooling or heating performance may be reduced.
• Do not operate unit with horizontal louvre in closed position.
When the air conditioner is to be used again:
• Use a dry cloth to wipe off the dust accumulated on the rear air intake grille in order to avoid the dust
being dispersed from the indoor unit.
• Check that the wiring is not broken off or disconnected.
• Check that the air filter is installed.
• Check if the air outlet or inlet is blocked after the air conditioner has not been used for a long time.
9.3 - CLEANING
9.3.1 - Cleaning the indoor unit and remote controller
Use a dry cloth to clean the indoor unit and the remote control.
A cloth dampened in cold water can be used to clean the indoor unit if it is very dirty.
The front panel can be removed and cleaned with water. Dry using a dry cloth.
Do not use a chemically-treated or anti-static cloth to clean the unit.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.
9.3.2 - Cleaning the air filter (fig. 26, 27, 28, 29 and 30)
A clogged air filter reduces the cooling efficiency of this unit. Please clean the filter once every 2 weeks.
a.
Lift the indoor unit panel up to an angle until it stops with a clicking sound (fig.
26).
b.
Take hold of the handle of the air filter and lift it up slightly to take it out from the filter holder (fig.
28a),
then pull it downwards (figure
28b).