Olimpia splendid ClimaPiu 12 HE HP, Руководство по установке и инструкции по использованию

Страница: 9 / 37

44
3.2.2 Internal unit assembly
Once the plate has been fixed, assemble the internal unit
using the following preocedure:
a) If the connection lines are at the back of the appliance,
a 100 mm hole must be drilled in the wall with an outward
5% gradient (fig. 4) in order to facilitate condensate
removal. The position of the hole is indicated in fig. 2.
The best procedure is to make a preliminary hole in the
wall with a 8-10 mm nail in correspondence with the
centre of the hole to be drilled and then bore the
definitive hole using a drill with a guided cup. If there is
an "external air intake" included in the appliance, then a
hole must be drilled for this also, in the position indicated
in the instructions supplied with the accessory and
assemble it in accordance with these instructions.
b) Insert the condensate removal line, cooling line and the
wires for electrical connection or the raceway in which
they are contained into the hole.
c) Remove the applianceis front panel in the following
manner (fig. 5):
-
remove the three screws from the air outlet and the
other two from under the upper door,
- grip the frontal panel from below, turn it upwards to
free it from the lower part,
- lift the panel in such a way as to unhook it from the
two hooks under the upper door.
d) Bend the lines to the right (fig. 6) in the direction of the
connections. Use a tube bending spring to avoid
"pinching" the lines.
ESTERNO INTERNO
Fig. 4
Fig. 5
Fig. 6
CEILING
INSIDE OUTSIDE
5% SLOPE