Olimpia splendid CALEO 2 TURBO TIMER, Инструкция по установке, использованию и техническому обслуживанию

Страница: 29 / 96

CALEO 2 TURBO
ENGLISH
EN- 11
1 - IDENTIFICATION OF MAIN PARTS (fig. 1)
1. Hot air outlet
2. Thermostat knob
3. Power switch/power selector
4. Feet
5. Fan
6. Air inlet
1.1 - SUPPLIED ACCESSORIES
- n° 2 support feet
- n° 3 brackets for wall-mounting
- n° 3 wall plugs
- n° 7 screws for fixing the feet and
handle
- use and maintenance
warrant module
- handle for moving (fig. 2)
2 - INSTALLATION
2.1 - MOUNTING SUPPORT FEET TO THE FLOOR
- Position the 2 teeth of the support feet in the 2 respective slots on the bottom of
the appliance.
- Push the feet towards the inside of the appliance so that their teeth are blocked
to the frame of the product (fig. 3).
- Make sure each foot is blocked with the 2 supplied screws (fig.4).
2.2 - WALL-MOUNTING THE APPLIANCE
When wall-mounting, the wall to which the appliance is fixed must be in masonry or heat
resistant material (not in wood or easily heated synthetic material):
The installation must be done as follows:
- At a distance of at least 60 cm from baths, washbasins or sinks
- At a distance of at least 20 cm walls.
- At a distance of at least 100 cm from flammable materials (curtains, textiles etc.)
- Not below a mains socket.
- Install a mains socket nearby for the power supply to the appliance.
- Make 2 holes in the wall for the 2 supplied wall plugs. The centredistance between
the 2 holes must be 330 mm. Both holes must be at least 400 mm from the floor
and 600 mm from the ceiling.
- Insert the plugs in the holes in the wall and then fix the 2 upper mounting brackets
(the smaller ones) to the plugs, using the screws supplied with them. Make sure
that the slot on the 2 mounting brackets are facing upwards. (fig. 5).