Olicom CrossFire 8720, Руководство по установке

Страница: 24 / 66

15
CrossFire 8720 Fast Ethernet Layer 3 Switch, v. 1.00.02, P/N: 710001800 Installation
Connecting Devices to the Ethernet Ports Using Building Wiring
If you are using building wiring (in-the-wall cables) to connect the device to the
switch, perform the following steps:
1. If you have a UEM, connect it using the instructions in the documentation
shipped with it, then follow this procedure.
2. Following the Switch Cabling Chart provided by your administrator, connect
the cables between the devices and the faceplates as illustrated in figure 4.
3. To ease troubleshooting, label the faceplate.
4. In the wiring closet, connect a cable to the Ethernet connector on the patch
panel or other equipment where the building wiring terminates.
5. Connect the other end of the cable to an Ethernet port on the switch.
6. Label this cable.
7. If the switch is rack-mounted, thread the switch end of the cables through a
cable management bracket, if one is present on your rack. See Applying Power
on page 16.
Figure 4. Connecting Using Building Wiring