Construction Manual
www.oldschoolmodels.com
Page 17
For more information on all of our other products, as well as the latest news from Old School Model Works:
Please check out out website: www.oldschoolmodels.com
You can reach us on Facebook: www.facebook.com/oldschoolmodelworks
Instagram: www.instagram.com/oldschoolmodelworks/
Twitter: www.twitter.com/oldschoolmodels
See photos of our kits and customer builds on Flickr: https://www.flickr.com/photos/oldschoolmodelworks/
Recommended Control Throws:
The amount of control throw should be adjusted as closely as
possible using mechanical means, rather than making large
changes electronically at the radio.
By moving the position of the clevis at the control horn toward
the outermost hole, you will decrease the amount of control throw
of the control surface. Moving it toward the control surface will
increase the amount of throw. Moving the pushrod wire at the
servo arm will have the opposite effect: Moving it closer to center
will decrease throw, and away from center will increase throw.
Work with a combination of the two to achieve the closest or exact
control throws listed.
Aileron 1/2” up/down
Elevator 1/2” up/down
Rudder 3/4” left/right
These control throw are suggested and work well. We ask that
you start with these settings, then adjust them as needed as you
become familiar with the flying characteristics of your Mambo.
Preflight:
Charge both the transmitter and receiver pack for your airplane.
Use the recommended charger supplied with your particular radio
system, following the instructions provided with the radio. In most
cases, the radio should be charged the night before going out
flying.
Check the radio installation and make sure all the control
surfaces are moving correctly (i.e. the correct direction and with
the recommended throws). Test run the engine and make sure it
transitions smoothly from idle to full throttle and back. Also ensure
the engine is tuned according to the manufacturer’s instructions,
and it will run consistently and constantly at full throttle when
adjusted.
Check all the control horns, servo horns and clevises to make
sure they are secure and in good condition. Replace any items
that would be considered questionable. Failure of any of these
components in flight would mean the loss of your aircraft.
Range check your radio before flying
Before each flying session, range check your radio. This is
accomplished by turning on your transmitter with the antenna
collapsed. Turn on the radio in your airplane, but do not attach the
arming switch.
With your airplane on the ground, you should be able to walk 30
paces away from your airplane and still have complete control of
all functions.
If not, don’t attempt to fly! Have your radio equipment checked
out by the manufacturer.
Warranty Information
Old School Model Works
guarantees this kit to be free from defects in
both material and workmanship at the date of purchase. This warranty
does not cover any parts damage by use or modification. In no case
shall
Old School Model Works’
liability exceed the original cost of the
purchased kit. Further,
Old School Model Works
reserves the right to
change or modify this warranty without notice.
In that
Old School Model Works
has no control over the final assembly
or material used for the final assembly, no liability shall be assumed nor
accepted for any damage of the final user-assembled product. By the act
of using the product, the user accepts all resulting liability.
Limit of Liability
In the use of this product, our only obligation shall be to replace such
quantity of the product proven to be defective. The user shall determine
the suitability of the product for his or her intended use and shall assume
all risk and liability in connection therewith.
If the buyer is not prepared to accept the liability associated with the use
of this product, the buyer is advised to return this kit immediately in new
and un-opened condition.