10
TO TURN OFF GAS TO APPLIANCE
1.
Remove control access panel below grate.
2.
Push in gas control knob slightly and turn clockwise to “OFF” position. Do
not force.
3.
Replace control access panel below grate.
Note: There will be some delay after the pilot light valve is compressed before the
piezo igniter will light the pilot due to the air remaining in the control valves etc. If
after about 3 to 5 minutes the piezo igniter still fails to light the pilot, the pilot may
be lit manually as follows:
(1) Position the control knob to “PILOT” position.
(2) While depressing the control knob, light the pilot from beneath with a match.
(3) Hold the control knob down for 60 seconds.
(4) Contact your service technician or gas supplier to replace the defective unit.
The flame level has been preset for relatively small changes in BTU level. At first
ignition, only the blue and yellow flames will be visible. After a few minutes, the
coals on the rear stack will start to glow. The amount of glow and the height of the
flames are restricted due to the critical nature of the exhaust gas constituents. This
level has been tested extensively and a copy of the test results have been included
in the shipment. Should any of the coals become mislocated and the flame pattern
changes drastically, contact your distributor or call Old Salem Hearth immediately.
The Regency unit is repairable only at the manufacturer.
If a remote control system is to be used refer to drawing below.