ESDX-3420_Rev03102008
1.
Remove the dome cover from the mounting base by
rotating the dome cover clockwise.
2.
Adjust the camera viewing angle by first tilting it, and then
rotate the camera module. Then turn the horizontal
adjustment ring to correct the image and achieve proper
orientation.
3.
Once the installation is complete, replace the dome cover
over the camera and tighten it by turning counter
clockwise.
4.
Connect the video output to the monitor or other video
device through a 75 Ohm type coaxial cable and the
DC-Jack or AC/DC-Terminator to the power source.
Note: Power adapter is sold separately.
One (1) ESDX-3420 or ESDX-3420P Dome Camera with
power/video cable
Four (4) Mounting Screws
One (1) Operational Manual
Model
ESDX-3420 ESDX-3420P
TV System
NTSC PAL
Image Sensor
1/3” Sony Super HAD CCD
DSP
Sony
Total Pixel
510(H) x 492(V)
500(H) x 582(V)
Synchronizing
System
Internal
Resolution
420 TV Lines
Minimum
Illumination
0.3 Lux @ F2.0
S/N Ratio
More than 48dB
Auto Gain Control
Auto
White Balance
Auto
Gamma
0.45
Electronic Shutter
1/60~1/100,000sec 1/50~1/100,000sec
Video Output
1Vp-p composite / 75
Ω
Lens
3.6mm Board Lens / F2.0
Power Supply
12V DC
Power
Consumption
130mA
Operating
Temperature
-10°C ~ +50°C
Dimension
62mm x Ø 87.5mm
SPECIFICATIONS
INSTALLATION
PACKAGE CONTENTS
Top
Rotate
Ti
lt
Top
To
p
Camera
Module
Horizontal
Adjustment
Ring
