OKIDATA OL600e, Руководство по обслуживанию

Страница: 58 / 246

Page: 30
Service Guide OL600e/610e/610ePS
Chapter 3 Parts Replacement
3. PARTS REPLACEMENT
The section explains the procedures for replacement of parts, assemblies, and units in the field. Only the
disassembly procedures are explained here. For reassembly, reverse the steps of disassembly procedure.
3.1 Precautions for Parts Replacement
Note: Always use proper anti-static precautions. (1) Before starting the parts replacement, remove the AC
power cord and interface cable.
(a) Remove the AC power cord in the following sequence:
i) Turn off ["O"] the power switch of the printer.
ii) Unplug the power cord from the AC outlet.
iii) Disconnect the power cord and interface cable from the printer.
(b) Reconnect the printer in the following sequence.
i) Connect the AC power cord and interface cable to the printer.
ii) Plug the power cord into the outlet.
iii) Turn on ("l") the power switch.
(2) Do not try to disassemble as long as the printer is operating normally.
(3) Do not remove parts which do not need to be touched; try to keep disassembly to a minimum.
(4) Use specified service tools.
(5) When disassembling, follow the procedure in sequence laid out in this manual. Parts may be damaged
if these sequences are not followed.