ML620/ML621 User’s Guide
0
Make sure the tractor assembly is in the front of
the printer. If the tractor is in the back, remove
the sheet guide, grab the finger guides (1) on
each side and pinch them together to release the
guide. Remove it from the back and insert it into
the front feed and when it is seated, push down
to snap the guides in place. Replace the back
sheet guide.
Pull up on the lock levers to release them.
You will find reference marks on the printer for
the most common paper sizes.
Move the left tractor to the position to match
your paper size and push back on the lever to
lock it in place, then move the right tractor to fit
the width of the paper.
Open the tractor covers and place continuous
forms paper on the first two pins of either tractor,
then close the
left
tractor cover.
.
.
.
.
.
Important!
You must keep the number of paper holes engaged on
either pin the same. If you don’t the paper will skew
and jam.
Adjust the position of the right tractor to center
the holes in the paper on the pins. Then, close
the tractor cover and push back the lock lever. Do
not stretch the paper.
Note: If the paper is too loose or too tight it can cause
jams.
Press and hold the
LOAD/EJECT
key to advance
the paper.
Note: The factory default setting for the Top of Form
(where the printing should begin) is 11/12”
(23.28 mm) down from the top of the page. To
change the setting, see “Top of Form (TOF)”.
.
.
1
1
