Oki Microline 182, Руководство по обслуживанию

Страница: 18 / 210

3.2.2
Control board
Remove the upper cover 3.2.1).
Remove serial interface board by removing two screws locating on both sides of
interface connector. Remove interface board upward installed).
Remove transformer connector from control board
Remove three screws and two screws
Remove control board by upward (see Notes below).
end lever when removing the PCB.
Before reassembly, secure rubber insulator installed.
For reassembly, reverse the disassembly procedure..
Do the terminal (contact) @for
connector
with hand and make
sure that if clean.
2. When affachin make sure that pa er near-end lever is c/ear in the groove of
phofosensor 8 on control board 1
3 - 4