Oki C3100, Руководство пользователя

Страница: 73 / 86

INSTALLING ADDITIONAL MEMORY > 73
9.
If the RAM expansion slot already contains a memory upgrade
board, that board will have to be removed before you can
install the new one. To remove it proceed as follows, otherwise
skip to step 10.
(a)
Identify the locking clips (2) at each end of the RAM
expansion slot (1).
(b)
Push the clips outward and back into the printer. The
board will pop out slightly.
(c)
Grip the board firmly by its short edges and pull it out of
the slot.
(d)
Place the removed memory board in the antistatic bag
which originally contained the new memory board.
10.
Hold the new memory board by its short edges, so that the
edge connector faces in towards the RAM expansion slot, and
the small cutout is closer to the bottom of the printer.
11.
Gently push the board into the RAM expansion slot until it
latches in and will not go any further.
12.
Locate the three retaining clips at the bottom of the side cover
into their rectangular holes near the bottom of the printer.
13.
Close the top of the side cover up to the printer and refit the
securing screw removed in step 4.
14.
Close the front cover and close the top cover, pressing down
firmly at each side to latch it closed.
15.
Reconnect the AC power cable and switch the printer on.
16.
When the printer is ready, print a menu map by holding down
the ON LINE button on the Status Panel for 2 seconds.
17.
Examine the first page of the menu map.
Near the top of the page, between the two horizontal lines, you
will see the current printer configuration. This list contains the
figure for total memory size.
This should indicate the total memory now installed, which
should be the size of memory board you have installed plus
32MB.