OKADA TOP Series, Инструкция и перечень запасных частей для владельцев и операторов

Страница: 56 / 64

56
Routine and periodic inspection
Part Check Item Countermeasure Frequency
Grease nipple(s) Grease-up Every 2 hours
All bolts and nuts Tightness Retighten Everyday
Chisel set pin(s) Wear or damage Replace Everyday
Flange plugs for retainers Tightness Retighten Everyday
Hydraulic oil
Insufficiency, deterioration or
contamination
Replenish or replace Everyday
Replace Every 600 hours *
2
Bracket Wear or damage Repair or replace Every 1 month or 100 hours *
1
Chisel Wear or damage Repair or replace Every 1 month or 100 hours *
1
Hydraulic oil filter Replace Every 100 hours *
2
Back cap N
2
gas Gas pressure Charge N
2
gas Every 3 months or 300 hours *
1
Shank bushing Wear or damage Remove flaws or replace Every 3 months or 300 hours *
1,
*
3
Front cap bushing Wear or damage Remove flaws or replace Every 3 months or 300 hours *
1,
*
3
All seals Replace
Every 12 months or 1000 hours *
1
Accumulator bladder Replace Every 12 months or 1000 hours *
1
Valve Flaws on the sliding surface Repair flaws Every 12 months or 1000 hours *
1
Cylinder
Flaws on the inner surface,
loosen plug
Repair flaws, retighten Every 12 months or 1000 hours *
1
Cylinder sleeve Flaws on the inner surface Repair flaws Every 12 months or 1000 hours *
1
Piston Flaws on the inner surface Repair flaws Every 12 months or 1000 hours *
1
*
1
Take steps, whichever comes first.
*
2
As prescribed by the carrier machine manufacturer.
*
3
Refer to the “Wear limit dimension of parts” for visual decision.
●
Shorten the inspection and replacement frequency if the breaker is repeatedly used continuously for many hours.
●
The numbers above are not to assure the lifetime of each part.