34
ERROR INDICATION AND TROUBLESHOOTING
Error indication shown in display and remedy
Follow below table to understand error messages and to remedy. Error messages are shown in display
during use.
Error
message
Reason
Alarm signal
Remedy
is flashing Water tank full or pump
error
–
• Empty condensation water tank.
• Check drainage and make sure it
is not blocked
• If the error code is sill shown
there, contact your service agent.
is flashing Air circulation blocked
–
• Clean the lint filter.
• Open the service flap of air inlet
and make sure grill and filter are
not blocked.
E30
Error of heating system
If the error code
is shown an
alarm signal
occurs every 15
minutes.
• Contact your service agent
E32
Error of humidity sensor
E33
Error of temperature sensor
Front temperature sensor
(E33)
Rear temperature sensor
(E34)
E34
TROUBLESHOOTING
Problem
Solution
Display doesn’t work
• Power supply
• Check preset program
• Check fuses of you electric supply
Dryer doesn‘t start
• Make sure the door is closed
• Chose correct program and push button Start/Pause
Water leakage
• Align dryer horizontally.
• Check air condenser, sealing cap and drainage and make sure it is
installed correctly.
• If the problem persists contact your service agent.
Door opens by itself or cannot
be closed
• Close door slowly until it clicks. Do not slam the door.
• Remove clothes if overloaded
Humidity in the room
increasing significantly
• Ventilate room adequately.
• Clean the air inlet grille.
• Ensure that the air condenser has been inserted.
Degree of dryness not
reached or drying time too
long
• Clean lint filter and wash condenser.
• Empty condensation water tank.
• Clean the moisture sensors.
• Use next higher drying program or use Timer program.
IM_OTD28111_150320_V04_HR.indb 34
20/3/15 6:29 PM