22
EN
INSTALLATION
Placement
When choosing an installation place, consider following points:
• Observe all safety warnings!
• Ensure the minimum surrounding distance in every direction of 30 cm and 100 cm to other electrical
products.
• Keep a surrounding distance of minimum 50 cm around the outside of exhaust wall outlet and protect
it from entering objects and moisture.
• Make sure the wall behind the product is an exterior wall not a divider and the drill holes can be made
in a safe way, not obstructed by hidden objects in the wall.
• Ensure that a suitable power outlet is within reach at the desired location and remains accessible after
installation.
• Consider that during dehumidifying operation water is collected inside the product, which must be
continuously drained through a connected drainage hose into a suitable container or a nearby drain.
• Ensure there are no obstacles obstructing the airflow.
Air exhaust
The exhaust hose and adaptor must be installed or removed in accordance with the usage mode:
• COOL, AUTO mode: install exhaust hose.
• FAN, DEHUMIDFY mode: remove exhaust hose.
Wall (Parts: N, O, P, Q)
Fig.
1
Screw the wall adapter and exhaust adapter onto each side of the exhaust hose. Connect
the exhaust adapter to the air exhaust of the product.
Fig.
2
Use the wall connector as pattern to mark the hole spacing on the wall. Drill the holes
with a suitable power tool. Free the holes from dust and mount the wall connector using
supplied screws and plugs. Connect the wall adapter to the wall connector.
Note:
• The exhaust hose can be expanded and compressed, but for optimal performance, keep
the exhaust length to a minimum.
• Do not extend the exhaust hose.
• Avoid over-bending.
• Observe the decommissioning instructions in the respective section, if the product is
not to be used for a longer period of time.
Window (Parts: N, O, R)
Fig.
3
The exhaust hose can be attached to an open or tilted window alternatively. Screw the
window outlet adapter onto the open end of the exhaust hose.
Note: Material necessary for attachment and sealing is not provided but must be
purchased in special shops.
Drainage hose
Fig.
4
The drainage hose is used to drain water from the upper drain outlet.
1.
Slide the drainage hose as far as possible onto the outlet.
2.
Lead the other end of the drainage hose into a suitable container or a nearby drain.
Notes:
• Depending on the set modus the water is either drained directly or collected in an internal
tank. Drain the water respectively.
• Always cover the drain outlets when not in use.
• Observe the decommissioning instructions in the respective section, if the product is not
to be used for a longer period of time.
IM_OAC2221_161201_V04_HR.indb 22
1/12/16 4:31 PM
