3-3
6600-0371-000
10/27/03
3/Operation
3-3
This switch is used to select either the Manual or Servo mode of operation. An audio tone
sounds momentarily when the mode switch is depressed.
Increase (
M
M
M
M
M
) and Decrease (
?
?
?
?
?
) Switches:
These switches are used to set the radiant power level (% power) in the manual mode
and to set the control temperature in the servo mode.
Alarm Silence:
This switch is used to silence the audible alarm. It silences all alarms except the system
failure alarm. Refer to Table 1 - Warmer Alarms for details on how long the audible alarms
are silenced.
Holding this switch depressed for five seconds or longer activates the audible alarm and
lights all the indicator lamps for testing purposes.
Start/Hold:
This switch activates the elapsed timer. Refer to the elapsed timer operation, Section 3.3,
for a detailed explanation of its function.
Reset:
This switch is used to reset the elapsed timer to “00:00”.
Apgar Tones On/Off:
This switch activates the Apgar tones. When the Apgar tones are activated, a short alarm
tone is sounded at one minute and every five minute interval after the elapsed timer is
started.
Light On/Off:
This switch activates the observation light located in the heater assembly.
WARNING:
w
Prolonged exposure to the light emitted by the observation lamp in this
unit may harm the unprotected eyes of the infant. For safety, cover the
infant’s eyes.
Raise Bed (
M
M
M
M
M
) (Elevating Models Only)
WARNING:
w
Check for proper clearance above the Warmer and below the bed surface
before raising or lowering the bed.
w
Inspect all patient connected tubes or wires before and after moving or
tilting the bed. Tilting or moving the warmer bed up or down can pull on
tubing or leads connected to the patient. This may disconnect tubes or
leads, restrict gas or liquid flow, or move sensors out of position.
CAUTION:
w
Do not continue to run the motor at the upper and lower limit positions; equip-
ment damage may result.
This switch raises the bed to a maximum height of 118 cm from the floor.
Lower Bed (
?
?
?
?
?
) (Elevating Models Only)
This switch lowers the bed to a minimum height of 98 cm from the floor.
6600−0371−000−DWG
100
MANUAL−DOC, User Reference Manual, OM Panda, English−default
Reproduced from the electronic master in MATRIX
