OHM ELECTRIC COOL CABI OCA-H1000BC-AW2, Инструкция по эксплуатации

Страница: 32 / 88

32
Avoid using other filters than enclosed.
→ Use of fine filters will cause efficiency loss in heat releasing, and thus leads to decline in cooling
performance or breakdown of the product.
Condensate water in the cooling unit may spill out if the cooling unit is moved after operation for
dismounting or relocating or the enclosure itself to which it is attached is moved.
Children and persons with reduced physical, sensory or mental capabilities or lack of experience and
knowledge should not use this product, unless they have been given supervision or instruction
concerning use of the cooling unit by a person with experience and knowledge.
Supervise children to prevent them from playing with this product.
This product uses R 34yf as refrigerant. Please use it in accordance with the safety regulations of your
country.
Warning
The cooler uses a slightly flammable refrigerant.
If there is a refrigerant leak, thoroughly ventilate the area and do not allow fire near the cooler.
Do not use means to accelerate the defrosting process or to clean, other than those recommended by the
manufacturer.
The appliance shall be stored in a room without continuously operating ignition sources for example: open
flames, an operating gas appliance or an operating electric heater .
Do not pierce or burn. Be aware that refrigerants may not contain an odor.
Detection of flammable refrigerants.
Under no circumstances shall potential sources of ignition be used in the searching for or detection of
refrigerant leaks. A halide torch or any other detector using a naked flame shall not be used.
Leak detection methods.
The following leak detection methods are deemed acceptable for all refrigerant systems.
Electronic leak detectors may be used to detect refrigerant leaks but, in the case of flammable refrigerants,
the sensitivity may not be adequate, or may need re-calibration.
Detection equipment shall be calibrated in a refrigerant-free area. Ensure that the detector is not a
potential source of ignition and is suitable for the refrigerant used. Leak detection equipment shall be set
at a percentage of the L L of the refrigerant and shall be calibrated to the refrigerant employed, and the
appropriate percentage of gas 5 % maximum is confirmed.
Leak detection fluids are suitable for use with most refrigerants but the use of detergents containing chlorine
shall be avoided as the chlorine may react with the refrigerant and corrode the copper pipe-work.
If a leak is suspected, all naked flames shall be removed extinguished.
If a leakage of refrigerant is found which requires brazing, all of the refrigerant shall be recovered from the
system, or isolated by means of shut off valves in a part of the system remote from the leak. or appliances
containing flammable refrigerants, oxygen free nitrogen O N shall then be purged through the system
both before and during the brazing process.
Do not scratch or puncture the piping, or work near fire sources while operating.