12
RXF34 M.2 FRONT FORK 100 H SERVICE
Note!
1
Clean all parts using disc brake cleaner and a rag to remove dirt, old grease and
thread sealant before reassembling. Lubricate new o-rings/x-rings etc. with fresh
assembly grease if no other grease is specified.
24.
Apply 1ml of air spring lubrication fluid inside the negative
chamber.
25.
Gently push the seal head into the stanchion tube. It should
come to a firm stop about 6 mm from the edge of the stanchion tube
if the inner circlip (00329-21) is properly seated.
Important! Clean the outer most circlip groove from any
remaining grease using a rag and disc brake cleaner. Failing to
do so might cause the circlip not to seat itself properly in the
groove.
26.
Install the new circlip (19528-01). Be careful not to damage the
piston rod surface while installing the circlip.
Important! Make sure the circlip is properly seated in the
groove before continuing.
24
25
26