!
WARNING!
Use of infl ammable gas for pressurising
the soch absorber can be hazardous.
Use
nitrogen gas (N2) only!
19.
Check the gas pressure stipulated in the
spec. card. Dip the needle of the gas tool
(1781-01) in red grease and insert the nee-
dle through the gas filler valve.
Charge with gas to the correct pressure,
according to the spec. card.
NOTE!
Ensure that there is no leakage of gas or
fl uid.
20.
Screw the gas filler screw with O-ring.
Remove tool 2810-01 and tool 1797-04 to
release the top-out spring.
21.
Push tool 1765-03 to a stop and check the
oil level according to page 17.
NOTE!
Use Öhlins Front fork oil 1305-01 only.
22.
Refit the Pre-load tube. Install the spring
and refit the adjustment driver.
23
Refit the top nut assembly to the piston
shaft. Tighten the jam nut to 20 Nm.
24.
Refit the top nut into the fork leg (use tool
797-01). Adjust the preload, compression
and rebound.
CAUTION!
The top nut should only be tightened by
hand into the fork leg. The tightening force
of the triple clamp will hold it in locked
position.
24
Tool 797-01
CAUTION!
21
Check the oil level
1305-01
NOTE!
22
23
20 Nm
19
!
WARNING!
20
16
3 Nm
Tool 1765-03
