OHAUS SJX323, Инструкция по эксплуатации

Страница: 7 / 124

SCOUT
TM
SJX SERIES BALANCES EN-5
Figure 3-2. Scout Display
TABLE 3-2. Display Symbols
Item Description Item Description
1 Battery charge symbol 8 Kilogram, grain symbols
2 Stable weight symbol 9 Check Weighing symbols
3 Negative symbol 10 Pound, Ounce, Pound:Ounce symbols
4 Center of Zero symbol 11 Percent, dwt, g/mol symbols
5 NET symbol 12 G (Gravity), Pieces, t hk, t sg, t tw, H ( Hold)
symbols
6 Preset Tare symbol 13 Newton, Totalization, Dynamic, Bluetooth
symbols
7 Pointer symbols
3.2 Turning Balance On/Off
To turn the balance on, press and hold the
On/Zero Off
button for 1 second. The balance
performs a display test, momentarily displays the software version, and then enters the active
weighing mode.
To turn the balance off, press and hold the
On/Zero Off
button until OFF is displayed.
3.3 Calibration Operation
When the balance is operated for the first time, a span calibration is recommended to ensure
accurate weighing results. Before performing the calibration, be sure to have the appropriate
calibration weights. Ensure that the Security switch is set to unlocked position.
SJX/E:
Press and hold
Menu
until [
mMeNU
] (Menu) is displayed. When the button is released, the display
will show [
C.A.L
]. Press
Yes
to accept. [
SpaN
] will then be shown. Press
Yes
to begin the span
calibration.
[
--C--
] will be displayed while zero reading is stored. Next, the display shows the calibration
weight value. Press the
No
key toggle the value. Place the specified calibration mass on the
pan. [
--C--
] will be displayed while the reading is stored. The display will show [
done
] if the
calibration was successful. The balance returns to the previous application mode and is ready
for use.
2
3
4
1
5
6
8
9
10
11
12
13
7