OHAUS i-DT33XW, Инструкция по эксплуатации

Страница: 12 / 84

EN-10
SETUP
USB Device Function
A. The OHAUS Interface is preset to communicate using the following settings:
9600 baud, 8 bits, no parity, no handshake. Check the USB device
parameters required for the printer or computer that is to be connected. See
the computer or printer documentation if assistance is required. If the
parameters do not match, you will need to change either the indicator's, the
computer's or the printer's settings.
B. Upon installation of the interface, the indicator will recognize the USB device
interface and add relevant items to the menu.
CONFIGURATION
If the USB board is not connected, the submenu will not display.
USB
Reset
no , yes
Baud Rate
300, 600, 1200, 2400, 4800, 9600 ,
19200,38400, 57600
Parity
7 Even, 7 Odd, 7 None, 8 None
Stop Bit
1 bit , 2 bit
Handshake None , Xon/Xoff
Alt Print CMD 'A' ~ 'Z', P
Alt Tare CMD 'A' ~ 'Z', T
Alt Zero CMD
'A' ~ 'Z', Z
End \
For printing template setup, please refer to the following table
Print Setup
Reset no , yes
Assignment
Demand , Auto On Stable, Auto On
Accept, Interval (seconds), MT-
Continuous, OH-Continuous, SICS
Stable Weight Only
[Demand]
Off , On (LFT is forced to be On)
Mode [Auto On Stable] Load , Load and Zero
Time [Interval(seconds)] 1 ~5000
Link to [OH-Continuous] Off , Custom 1, Custom2
Checksum [MT-
Continuous]
On, Off
Template
Custom 1 , Custom 2
End \
Note : \ refers to not applicable in the table above.