Oh!FX SIR-FOAM/M, Руководство по установке

Страница: 7 / 20

INSTRUCTION MANUAL
7
1- Assembling: To assemble the acquired FX head, you must previously remove the Sky
dancer head supplied from the turbine by loosening and removing the screws
Fix then the Foam cannon head on the turbine using the supplied screws, and lining up the
4 holes. Place the machine in the intended place, either on a fl at and stable surface or on a
tripod or even better on the fl ightcase we propose, by inserting the tube piece included with
the fl ightcase into the accommodation for tripod. In case of use of a tripod, make sure that
it can hold at least 50 kgs. Adjust the inclination of the machine (advisable about 45°) and
tighten the
locking knobs
. Using a tripod or the fl ightcase tripod, allows you to rotate the
machine, covering thus a larger area.
2- Water connection: Connect the Inlet Water tap supplied to the water connection of
the machine. With the water tap closed (on the image shown is open), you can connect the
water hose and open the main circuit of your water source.
The PREMIX connection
must
be covered with the supplied Stopper cap (this PREMIX connection only will be used in case
you need or wish to work with a water tank + a pump)
3- Foam fl uid Connection: Connect the absorption tube of foam fl uid supplied to the
foam fl uid connection
(FOAM). At the other end of this tube, there’s a fi lter, which must be
inserted into the foam fl uid bottle ready to use. Check that the stopcock (small black plastic
tap) is open. This small tap is to regulate the entry of foam fl uid, although it is better to leave
it completely open. Since the machine mixes the fl uid with the incoming water, it is better to
regulate the outfl ow of the machine with the Inlet Water tap and thus not to deregulate the
proportion of foam fl uid and water.
ASSEMBLY AND OPERATION
Detail of connections