Ogura Industrial Corp, Somerset, NJ, USA www.ogura-clutch.com
On the actual machine, make sure that the load can be started within the specified time
and stopped within the specified time and distance.
<<Burnishing of friction surfaces>>
If the specified torque is not output, pay attention to the following points when burnishing the
friction surfaces.
Pay attention to the temperature rise of the casing under the condition of less than half
of the allowable power of the catalog.
Perform break-in operation with a light load.
If the specified torque does not come out even after burnishing, please contact us.
3-3. Confirmation During Operation
1) Be sure to check the following points during trial run or before starting operation.
(a) Is the casing securely tightened?
(b) Is the exciting voltage the rated voltage at the terminal block of the clutch / brake?
(c) Does the armature operate smoothly by turning the switch ON / OFF?
Especially when starting to use after long-term storage, make sure that the output shaft rotates
smoothly when the clutch is turned on and stops when the brake is turned on before starting
operation.
2) Check the following points during the test run.
(a) Does the clutch work and the load is connected smoothly?
(b) Does the brake work and the load stops smoothly?
