Fabric Brush - Smoothes wrinkles and creases from fabrics
Follow the steps below to attach the accessories to the steam nozzle
⚫
Ensure the unit is turned Off and no steam emits from the nozzle.
⚫
Choose the required attachment and slide onto the steam nozzle.
⚫
Ensure the holes on the steam nozzle are aligned with the open slots on the accessories
so that steam does not get blocked.
⚫
CAUTION: To avoid burns do not attach accessories to the nozzle whilst steam is
emitting.
INSTRUCTIONS FOR USE
Filling the Water Tank
WARNING! Ensure the Garment Steamer is unplugged and cooled before re-filling the tank.
⚫
Ensure the Garment Steamer is unplugged and cooled before re-filling the tank.
⚫
Ensure you place the Garment Steamer on a flat stable surface, holding the Handle, twist
the nozzle section of the Steamer clockwise to release.
⚫
Fill the Garment Steamer using water, distilled or de- minerlised water.
⚫
Fill the Water Tank up to the MAX mark, do not over fill the tank.
⚫
Replace the Nozzle and twist to secure into place.
CAUTION:
⚫
Each use, save rubber stopper and do not throw away.
⚫
After each use,always allow then unit to cool for
14-18 minutes
before adding cold water;
cold water added to a hot boiler may cause hot water and steam to shoot from the fill
hole.
⚫
Extreme caution is required when pouring water into the water tank.
⚫
Never fill water past the Max fill line.
NOTE: