Ofs Staks benching assembly, Руководство пользователя

Страница: 3 / 15

3 ofs.com imagine a place® 800.521.5381 Assembly instructions
Staks benching assembly
1. Begin assembly of bench in its permanent location. Once assembled the bench will
be difficult to move.
2. Attach T-nuts to H-bases using M6 x 16mm (Part #: 1416448) screws. Screw
through mount plate from below and into T-nut.
3. Screw into T-nut only two or three turns, DO NOT tighten.
4. Attach toolbar by sliding T-nut into bottom grooved section of toolbar.
5. Align H-bases so they are perpendicular to the toolbars and all toolbars are in
a straight line.
6. Toolbars must be flush to edge of outside bases and centered on the middle base(s).
7. When toolbars are properly located, tighten screws.
Base assembly
90˚
Align H-bases
Ships with H-base
Part #: 1552073
T-nut
T-nut
Center base model:
6-42CHBA1
6-30CHBA1
Model numbers:
6-64HBA2
6-48HBA2
“O” leg model
Numbers:
6-64OBA2
6-48OBA2
Longer than end
base T-nut
Part #: 1552074