OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
9
Operation
Variable Mode
1. Place the mix water into the mixing cup and place the lid on top of the
container. Ensure that the potentiometer control knob is in the fully
counter-clockwise position.
2. Make certain that the
ST PT 1 / ST PT 2
switch (14) is in the center
position. Place the
MAN/AUTO - VARIABLE
(13) switch in the
Variable
position.
3. Increase the rotational speed of the blender by turning the control
Potentiometer (16) clockwise.
4. Reset the timer to zero by pressing the reset button (8).
5. After mixing is complete, clean the blending cup and lid as soon as
possible to prevent any cement from building up on the container.
1. Place the mix water into the mixing cup and place the lid on top of the
container.
2. Make certain that the
ST PT 1 / ST PT 2
switch (14) is in the center
position. Place the
MAN/AUTO - VARIABLE
switch (13) to the
MAN/
AUTO
position. Place the
MANUAL/AUTO
switch (15) switch to the
AUTO
position.
Once the switch is placed into the AUTO position, the blender
should start to accelerate. If the blender does not accelerate, reset
the timer by pressing the reset button (8).
When you initially start the unit, the rotational speed may exceed the
setpoint, but will stabilize within a few seconds.
3. After stabilization, reset the timer to zero again and immediately begin
adding the cement. You have 15 seconds to add the cement to the mix
water and place the lid on the container.
After 15 seconds the timer will automatically increase the rotational
speed to Setpoint 2. Ensure that the cement is added to the mix
water and that the lid is placed on the container in less than 15
seconds.
4. After mixing the cement at Setpoint 2 for 35 seconds the timer will
automatically stop the blender.
5. After mixing is complete, clean the blending cup and lid as soon as
possible to prevent any cement from building up on the container.
Operation
Auto Mode