Officine Gullo 20GG 304FU, Инструкция по установке

Страница: 26 / 48

EN
4
2 - Product Dimensions and Cutout Requirements
CUTOUT REQUIREMENTS
The surface of the entire back wall above the range and below the hood must be covered with a noncombustible material.
*Consult local code for exact location requirements.
ELECTRIC GAS
B B
*Suggested location
of utilities
2” (5.1) max. protusion from
wall for gas or electrical supply
3” (7.6)
4” 3/4 (12.3)
A
Min. 18” (45.7)
Min. 30” (76.2)
To bottom of
ventilation hood
Min. 48” (122)
Minimum
to Combustibles
Min. 18” (45.7)
Max. 13” (33)
Min. 6”
(15.2)
Min. 6”
(15.2)
C
(/(&75,& *$6
% %
6XJJHVWHGORFDWLRQ
RIXWLOLWLHV
´
´
(/(&75,& *$6
% %
´
$
0LQ ´
0LQ´
7RERWWRPRI
YHQWLODWLRQKRRG
0LQ ´
0D[ ´
0LQ´ 0LQ´
&
´
´PD[SURWXVLRQIURP
ZDOOIRUJDVRUHOHFWULFDOVXSSO\
30” 36” 48” RANGE
60” RANGE
OPENING WIDTH A & C B
Range 30”
Range 36”
Range 48”
48 1/8" (122 .2 ) 7”
( 17.8 )
Range 60”
60" (152.4) 2x6” (15.2)
Note: Clearances from non-combustible materials are not
part of the ANSI Z21.1 scope and not certied.
Clearances to non-combustible materials must
conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI
Z223.1/NFPA 54.
Minimum clearances:
Above cooking surface (above 36” [91.4 cm])
• Sides - 6” (15.2 cm)
• Within 6” (15.2 cm) side clearance, wall cabinets no
deeper than 13” (33.0 cm) must be minimum 18” (45.7
cm) above cooking surface
• Wall cabinets directly above product must be a minimum
of 48” (122 cm) above cooking surface.
• Rear - 0” with 9 ” backguard; 0” with non-combustible
rear wall.
Below cooking surface (36” [91.4 cm] and below)
• Install with zero clearance between adjacent combustible
construction below the cooking surface and the back and
sides of the appliance.
ADDITIONAL CLEARANCES:
For island installation, maintain 2-½ in. minimum from cutout
to back edge of countertop and 3 in. minimum from cutout
to side edges of countertop (see top view).
For installation in a stepped island, 12” (30.5 cm) minimum
clearance is required from the back or sides of the range to
a combustible riser. The island installation is not part of the
ANSI Z21.1 scope and not certied.
FLUSH ISLAND INSTALLATION
BACK
min 3” (7.6) min 3” (7.6)
min 2 1/2” (6.3)
30 1/16" (76.4) 6” (15.2)
36 1/16" (91.6) 7” (17.8)