Officezone RHIN-O-TUFF OD 3500, Инструкция

Страница: 3 / 29

OD
4000
PUNCH and OD 3500 COMBO BINDING STATION
Setup & Operator Manual
Issue 2 April, 99
Performance Design Inc.
The Office Duty (OD 4000) electric punch, shown on opposite page, has been designed to
punch most any job that may pass through your office. No matter what type of binding you
need to carry out, the OD 4000 can punch the job. It will punch up to 17 sheets of 2Olb
(80gsm) copy paper at one time while maintaining perfect alignment. The maximum punching
length is 11” or A4 European format. Any sheet smaller can be punched for the minimum size.
Combo Binding Station
The Combo Binding Station is a base unit that supports three differ-
ent binding modules. Each module attaches in a matter of minutes,
The attachment procedure will be located in the module instructional
section of this manual.
There are three optional attachments (modules) for the OD 4000 Punch and OD 3500 Combo
Binding Station.
These are:
Coil Inserter
The plastic spiral inserter will bind books up to 1-1/8" (28.6mm) thick
using coil diameter up to 1-1/4" (30mm). The unit attaches to the
right side of the Combo Binding Station or OD 4000 Punch using
two wing nuts for easy installation.
Wife C/oser
The wire closer is capable of binding books up to 1-1/8" (28.6mm)
thick. It uses wire sizes from 3/16" to 1-1/4". It has an adjustable
closing bar for the different size wires. Each end can be adjusted
independently to obtain a perfect close. The unit attaches to the rear
of the Combo Binding Station or OD 4000 Punch using four knobs.
Comb Opener
The comb opener will bind books up to 2” (51 mm) thick. The opener
has an adjustable ring opener control for exact book placement. The
unit attaches to the rear of the Combo Binding Station or OD 4000
Punch using four knobs.
All of the above modules can be ordered when ordering the OD 4000 Punch or the OD 3500
Combo Binding Station. Individual units can also be ordered at a latter date. Each unit can be
installed in a matter of minutes. The coil inserter can be attached and kept on the machine per
manently. If the Wire closer module is installed on the machine and the comb opener module
is required; the wire closer will have to be removed so that the comb opener can be installed.
The opposite is also true. It only takes a few minutes to detach any one of the modules to
install any other one.