Officezone RHIN-O-TUFF OD 3500, Инструкция

Страница: 16 / 29

Diagram 5a
Adjusting the paper stop.
Place the book on the top cover of the punch with the right side of the
book against the paper stop bracket. Adjust the paper stop (6) so the
holes of the book hang over the edge of the front cover on the OD 4000
punch. The holes should
hang over the edge just enough for the coil
to clear the cover. Tighten the knob located on the paper stop bracket. It
may be necessary to fine-tune this after a few books are bound for exact
placement.
f)
Adjusting the front table / lexan guide
The front table/lexan guide (7,7a, L? 7b) has two purposes. (FIRST):
When the lexan is in the closed position, rotated on top of the coil (7a),
it will assist the coil to insert smoothly into the book. You should use the
lexan guide with all books regardless of thickness. (SECOND): With the
lexan guide (plastic) in the open position, rotated away from the
machine, it acts as a support table 7b) for large books. For books over
9/16" thick, it may be necessary at times to start the coil into the book,
then split the book in half using the table to support one half of the book,
then finish the inserting of the coil. This method improves productivity.
Diagram 5b
,