STEP 3: Angle Adjustment to Lift Front Casters
This adjustment is to make sure the FreeWheel properly lifts the front casters off the
ground. The adjustment is based on the height of your wheelchair’s footrest from the
ground. Make sure you have completed the Set-up Guide STEPS 1 and 2, BEFORE
you complete this step.
1. Find a flat/level floor. While holding the handle, arrange the FreeWheel in the
“tail dragger” position (shown above).
2. Move your feet apart. The clamp requires 3/4” of space between your feet.
3. Lower the clamp over your footrest, hooking the rear end first, then setting it down
with clamp cup just in front of the footrest tube.
4. Lock down by putting pressure on the handle. The
locking action should feel very solid and secure.
The FreeWheel tire should be touching the ground. If it
is NOT touching the ground, you will need to adjust the
Angle Bolt.
1. Loosen bolts A, B and C, both sides.
Do NOT REMOVE, just loosen.
2. Tighten Angle Bolt if wheel is off the ground.
Loosen the Angle Bolt if the tire is too low..
3. Re-tighten BOTH SIDES of bolts A, B and C.
Angle Bolt
A
C
B
Page 3
