Important notes
Wrist orthosis
with thumb piece
The Dynamics wrist orthosis with
thumb piece
provides effective immobil
-
isation of the wrist and the thumb saddle
joint. The anatomically contoured alu
-
minium splints can be individually adjusted.
Three-dimensionally moulded inner padding
guarantees enhanced wearing comfort.
Dear user,
We are pleased that you have chosen a
product from Ofa Bamberg and would like
to thank you for putting your trust in us.
Please take a moment to read through this
product information carefully to ensure
optimum effectiveness of your Dynamics
product.
Ofa Bamberg wishes you a speedy
recovery!
←
Fitting instructions
The fitting instructions in pictures can be found on the fold-
over page at the beginning of the brochure.
1
To put on the orthosis, open all Velcro tapes and pull them through the
corresponding eyelet. Pull the orthosis over the wrist in such a way that
the hand and thumb opening are pointing away from your body and the
contoured aluminium splint is on the inside of your wrist.
2
First close the Velcro tape around the wrist, then the upper and lower
Velcro tape. The middle Velcro fastener can be adjusted afterwards if
necessary. Please ensure that the product is secure but not too tight in
order to prevent pinching.
3
Finally, wrap the Velcro tape around the thumb opening and fasten it.
Please note
–
The initial adjustment and strap
-
ping on of the product must be
carried out by qualified specialist
staff. The aluminium splints can
be moulded when cold.
–
Wear the product directly on
your skin. If it has to be worn in
combination with other products,
please discuss this with your doc
-
tor beforehand.
–
If you experience an unpleasant
sensation, intense pain or any
other problem when wearing
the product, then remove it and
contact your doctor or specialist
supplier.
–
We use a comprehensive quality
management system to check our
products. However, should there
still be reason for complaint,
please contact your specialist
supplier.
23_DYN_Handgelenkorth_mit_545105025_ble_20190411_7587.indd 8
08.05.2019 10:01:13