Oerlikon S12 Series, Руководство по обслуживанию

Страница: 21 / 56

21
CAUTION: Safety glasses must be worn during these next steps .
2
Remove Retaining Ring (1I) from the groove of Spindle (1A).
3
Remove Thrust Washer (1H) from the Spindle (1A).
4
Remove two Pipe Plugs (1P) from the Housing (1G).
5
Remove Pipe Plug (1Q) from Housing (1G).
6
Turn the unit over and carefully place the unit on a support base until the Shaft (1A) rests on
it. Ensure there is enough gap to lower the Housing (1G) down.
7 Use a dead blow hammer on the Housing (1G) flange to drive the inboard Bearing Cone
(1D) off of the Spindle (1A).
8
Lift the Spindle (1A) out of the Housing (1G).
9
Remove Lip Seal (1B) from the Housing (1G).
10
Using a hammer and punch drive the inboard Bearing Cup (1C) out of Housing (1G). Be
careful not to damage counter bore in the Housing (1G).
11
Turn the Housing (1G) over and drive the outboard Bearing Cup (1E) out of the Housing (1G).
Be careful not to damage the counter-bore in the housing.
12
Remove Bearing Cone (1F) from the Spindle (1A).
This concludes the Housing-Spindle Disassembly.