EMBEDDED
PLC BL2500 User’s Manual
Getting Started
OEM Technology Solutions
Page 13
If you are using RS232, on the
PC-PLC link parameters
window select COM port and press
Setup
button. Select
the baud-rate (19200 to 600) depending on the current
value of the Target PLC.
3. Select
Debug
menu
→
Debug
to open
the
Debugger
window. The
Debugger
window is displayed with a
No
application
message.
"
Note:
If
the
Debugger
window shows that an application is currently running (‘<application name>’
active) on the Target PLC, press
Stop
button
on the toolbar to stop the application
before downloading a new one. You can also stop the application from the
Debugger
window menu (
File
menu
→
Stop application
).
4. On
Debugger
window, select
File
menu
→
Download
.
Select “RABBIT: TIC code for Rabbit-based controllers” on
the Download window and press
Download
button.
5. A progress bar on the
Debugger
window will show the progress of the downloading process. Once
the downloading is completed, the application runs immediately and the
SpotLight
window shown
below is displayed.
Troubled? If you experienced problems running this application, such as an error message “Cannot install
communication” or “Cannot start download – target not ready”, follow this checklist:
1. Make sure that the TCP/IP connection between the Target PLC and your PC is alive (use ping
command). See Section 2.4.2 on how to configure TCP/IP parameters.
2. If connection is alive, repeat accurately the step-by-step instructions in this Section. Remember to put
correctly the Target Slave Number and the IP address of the Target PLC in the
PC-PLC link
parameters
window (Step 2).
3. If the Target PLC has already an application running, stop it before downloading a new one.
If you still can not run this sample application, go to Chapter 7 (FAQ and Troubleshooting) which contains
more information about how to troubleshoot your particular problem.