4
Operating Instructions and Parts Manual
24672
9/19
2019 OEMTOOLS
®
3X POWERPAK
WARNING
: Rechargeable Lithium batteries are
potentially dangerous and can present a serious fire
hazard if the battery is damaged or if the product is
improperly used.
1. DO NOT submerge the product in water, liquids or salt
water. As noted, this product is IP54 water resistant;
however, damage to cells can cause the battery to
overcharge or create an imbalance which may lead to
fire, property damage and/or personal injury.
2. DO NOT attempt to operate the jump start feature if the
battery is connected to a power source.
3. DO NOT attempt to charge using a charging cable that
is not specifically designed for this product. If there is
any question or doubt, contact OEMTOOLS
®
at 1-866-
458-2472 for assistance.
4. DO NOT attempt to charge the battery at temperatures
below 40°F (4°C). Failure to comply may cause a
chemical reaction within the battery cells that presents
the possibility of product failure, fire and/or explosion
during the charging process.
5. While there are safety measures programmed, NEVER
allow clamps to touch each other or contact the same
piece of metal.
6. DO NOT drop a metal object or tool onto this product
while the product is in use. This may create a spark,
increasing risk of fire, explosion, property damage
and/or personal injury.
CHARGING THE UNIT
WARNING
: NEVER CHARGE UNIT UNATTENDED.
Charge immediately after purchase, and every 3-6 months
(if the product is not in use) to keep the internal battery fully
charged and prolong battery life. Charge after use. If used
to jump start, allow unit to cool down for 15-20 minutes
before charging.
WARNING
: DO NOT set the unit on flammable
materials, such as carpeting, upholstery, paper,
cardboard, etc.
NOTE
: If the battery will not charge, the charger may
be compromised. If the unit indicates a full charge while
connected to a power source, but indicates a lower
charge once removed, contact OEMTOOLS
®
at
1-866-458-2472 for assistance (please have your receipt/
PO # available when contacting our service team).
1. Upon initial purchase, this tool should be charged for a
minimum of 6 hours.
2. Connect to the provided AC adapter, and plug into a
standard 110V outlet.
3. To disconnect, hold the AC adapter by the plug, not
the cord (to prevent damage).
NOTE
: Reference Charging Status and Power Indicator
table to understand charging status.
CHARGING STATUS AND POWER INDICATOR
LIGHT
INDICATOR
CHARGING STATUS
1 BLUE LIGHT
Low Charge – Charge Immediately
2 BLUE LIGHTS 25%-50% Charge – Charge Soon
(Do Not Jump Start)
3 BLUE LIGHTS 50%-75% Charge – Charge If Using
Jump Start Function
4 BLUE LIGHTS 75%-100% Charge – Jump Starter Can
Be Used
Figure 1
