OEG 150, Инструкция по установке и эксплуатации, Страница: 28 / 100

28
Fresh-water, Combined and Buffer Storage Tanks
GB
Notes on safety and use 2 .0
Documentation 2.1
This installation and operation manual is absolutely necessary to read before
commissioning / use of the storage tank!
It is also part of the scope of delivery, has to be handed over to the user and should
always be kept near the place where the storage tank is located.
IMPORTANT: We accept no liability for any damage caused by failure to observe
these instructions.
IMPORTANT: Technical data subject to change without notice. No liability is
accepted for printing errors.
Regulations and
provisions 2.2
The relevant provisions of DIN, DIN EN, DVGW, VDI, TRF and VDE as well as all local and
country-specific regulations, directives and standards for heating and water heating
systems as well as for drinking water installations must absolutely be adhered to.
If any specifications in this manual are in contradiction to the country-specific provisions,
the latter are preferable.
Work on the storage tank 2.3
Installation and commissioning as well as maintenance and repairs have to be performed
by authorised specialists (heating contractor / contract installation company).
Place of installation 2.4
The storage tanks may only be installed where there is no risk of frost. If there is a risk
of frost, the storage tank as well as all water-bearing valves and connection pipes have
to be drained.
At the installation location, it is necessary to ensure that there is sufficient room for
performing maintenance and repair tasks as well as an adequate load-bearing capacity
of the ground.
Distances to firing installations can be found in the manufacturer’s documents. According
to the firing installation ordinance, a minimum distance of at least 1 m is to be kept, e.g. to
solid fuel boilers because sparks could fly.