OEC UroView
®
2800 Table/Generator Functional Block Diagrams
53
Periodic Maintenance
Page 6 of 6
mA Generation Functional Diagram
kV Control Board LEDs
07/01
2800
GE OEC Training
g
28MA.DS4
J8
J4
J1
J2
J3
J11
J5
J7
J9
J10
DS1
DS2
DS3
DS4
DS5
DS6
DS7
DS8
18
TP5
TP9
TP7
TP4
TP3
TP6
TP8
TP1
TP2
F1
F2
DS9
DS9 (red) FPGA (U71) Configuration not accomplished
DS10 (red) :Board being reset
DS11 (red): Microprocessor halted
DS12 (yellow): R_CAN_X (system CAN bus receive)
DS13 (yellow): T_CAN_X (system CAN bus transmit)
DS14 (yellow): TX_TAV (transmit to service laptop)
DS15 (yellow): RX_TAV (receive from service laptop)
DS16 (yellow): TX_CONS (transmit to console)
DS17 (yellow): RX_CONS (receive from console)
DS18: future use
DS19 - 26 (yellow): Error Indication
During Power On Diagnostics the LEDs are off.
When the 8 LEDs are lit successively back
and forth from the center, the power
up diagnostics are completed, the
kV Control PCB is up and running.
When only DS 23 - 26 are lit,
a data base checksum problem.An error
is logged. Refer to the error code description.
When an application error occurs,
DS 20 and 22 blink on and off.
When the error is cleared the 8 LEDs
are lit successively again.
DS1 - Gate Cmd OK - Yellow
DS2 - 3.3V
DS3 - 5V
DS4 - -15V Input
DS5 - -15V Internal
DS6 - +15V Input
DS7 - +15V Internal
DS8 - DSP Ok - Yellow
10 11 12 13 14 15 16 17
19 20 21 22 23 24 25 26
BP1
TP1 - GND
TP2 - GND
TP3 - 3.3V
TP4 - int -15V
TP5 - GND
TP6 - +5V
TP7 - int +15V
TP8 - +1.8V
TP9 - GND
mA Generation Functional Diagram – kV Control Board LEDs