background image

 

1

PT-3208 (2) Operational Description 

 
 

 

z

 

Supplied Accessories 

Item Quantity 
Antenna 1 
Speaker/microphone jack cover 

 

 

Belt clip 

Screw set 

Instruction manual 

 

PREPARATION 

z

 

Charging the  Battery Pack 

The battery pack is not charged at the factory; charge it before use. 
Initially charging the battery pack after purchase or extended storage (greater than 2 
months) will not bring the battery pack to its normal operating capacity. After 
repeating the charge/discharge cycle two or three times, the operating capacity will 
increases to normal. 
 
 
 
 
 
 
 
 
 
 
 
 
Note: 

z

 

The ambient temperature should be between 41 and 104

°

F (5 and 40 ) while 

charging is in progress.Charging outside this range may not fully charge the 
battery. 

z

 

Always switch OFF the transceiver equipped with a  battery pack before charging. 
Using the transceiver while charging its battery pack will interfere with correct 
charging. 

z

 

The battery pack life is over when its operating time decreases even though it is 
fully and correctly charged. Replace the battery pack. 

 
Plug the AC adaptor cable into the adaptor jack located on the rear of the charger. 
Plug the AC adaptor into an AC outlet. 
Slide the  battery pack or transceiver with a  battery pack into the charger. 

z

 

Make sure the battery pack contacts are in contact with the charging terminals. 

z

 

The charger LED lights and charging begins. 

After charging the supplied KNB-15A battery pack for 8 hours, remove it or the 
transceiver equipped with it from the charger. 

z

 

The charger does not turn OFF automatically after charging is completed. 

z

 

DO NOT RECHARGE THE BATTERY PACK IF IT IS ALREADY 
FULLY CHARGED. DOING SO MAY CAUSE THE LIFE OF THE 
BATTERY PACK TO SHORTEN OR THE BATTERY PACK MAY 
BE DAMAGED. 

z

 

AFTER RECHARGING THE BATTERY PACK,DISCONNECT IT 
FROM THE CHARGER. CHARGING THE BATTERY PACK FOR 
MORE THAN 5 DAYS MAY REDUCE THE BATTERY PACK LIFE 
DUE TO OVERCHARGING.

Содержание PT3208

Страница 1: ...y pack will interfere with correct charging z The battery pack life is over when its operating time decreases even though it is fully and correctly charged Replace the battery pack Plug the AC adaptor cable into the adaptor jack located on the rear of the charger Plug the AC adaptor into an AC outlet Slide the battery pack or transceiver with a battery pack into the charger z Make sure the battery...

Страница 2: ...hone attachment point Using the antenna in these ways may damage the antenna and degrade your transceiver s performance z Installing Removing the Belt Clip z Installing the Cover over the Speaker Microphone Jacks If you are not using a speaker microphone install the cover over the speaker microphone jacks using the supplied 3 6mm screw Note To keep the transceiver water resistant you must cover th...

Страница 3: ...n decreases the amount of power used when a signal is not being received and no operations are being performed no keys are being pressed and no switches are being turned While the channel is not busy and no operation is performed for 10 seconds Battery Save turns ON When a signal is received or an operation is performed Battery Save turns OFF z Low Battery Warning Low Battery Warning alerts you wh...

Страница 4: ...Recharge or replace the battery pack z The battery pack may not be installed correctly Remove the battery pack and install it again Battery power dies shortly after charging z The battery pack life is finished Replace the battery pack with a new one Cannot talk to or hear other members in your group z Make sure you are using the same frequency and Quiet Talk tone as the other members in your group...

Отзывы: