CONTINUED »
MENU SYSTEM
RECORD TRIGGER:
Allows selection of record trigger mechanism for Odyssey7Q.
Note that some cameras do not output trigger signals over
SDI or HDMI.
AVAILABLE RECORD TRIGGERS
RECORD BUTTON
(Tap Record Button on Upper Toolbar
to start/stop recording)
CAMERA
(Use camera’s trigger to stop/start recording --
trigger output must be enabled on camera)
TIMECODE
(Use detection of timecode incrementing to
start/stop recording -- Odyssey7Q TIMECODE must be set
to SDI/HDMI or LTC and timecode source set to Record
Run)
PROJECT RATE:
Determines playback frame rate from the SSDs. Note that
all incoming frames are always recorded, Project Rate
only determines the intended playback speed, which can
always be changed in post. The Project Rate can follow
the incoming source frame rate or be set to a specific rate
for faster or slower than real time playback.
FOLLOWS INPUT is the default setting, automatically
aligning to the incoming framerate at speeds 60p and
below. At higher incoming frame rates, 100/200p signals
have a default Project Rate of 25p and 120p/240p signals
default to 24p. This allows an even division of frames for
smooth playback.
AVAILABLE PROJECT RATES
FOLLOWS INPUT (default setting)
23.98 FPS
24.00 FPS
25.00 FPS
29.97 FPS
30.00 FPS
48.00 FPS
50.00 FPS
59.94 FPS
60.00 FPS
TRIGGER BUTTON
(RECORD MODE ONLY)
Displays status of recording mode. When button is Red with a white circle it is ready to
record. When Gray there is no signal available to record. While recording, the button is
Blue with a white square and the background of the entire top menu is Red. If REC Button
is selected as the trigger then tapping button triggers record start/stop
☼
»
SETUP
»
RECORD TRIGGER:
»
RECORD BUTTON
SSD1 STATUS
(ALL MODES)
02:12
Displays record time available given current settings (HH:MM). Tapping button brings up
detailed information on SSD1 status.
26
