Odom ECHOSCAN, Руководство пользователя

Страница: 21 / 44

04/26/02 21
Revision 1.11
10- Apply power to the Junction Box and verify that all sensors data
streams are present.
11- Turn on the side scan computer (if present). Fine tune Side Scan
Gain on the LCDU if necessary (Setup menu).
Power-Up procedures are complete at this point. Once on site, or in open
water, the heading sensor should be checked for proper operation.
Multibeam calibration (as described in Section 5) or “Patch Tests” (as
described in the software manual) are normally completed prior to the
survey.
Example Survey System Configuration
The following procedure is only very basic example of system setup when
using
HYPACK for Windows 6.4 HYSWEEP (trademark of Coastal
Oceanographics). The complete and up to date manual may be
downloaded from Coastal’s web page “www.coastalo.com”.
HYPACK
Go to HYPACK for Windows 6.4 / Preparation program.
Select Initialization / File / New to create a new setup or
/Open to use one that already exists. Open Current if you
want to use the last setup. The “path to save to” is defined
when the file is saved.
ECHOSCAN Setup
1- Under Initialization , select Devices / Add Device and type a name for
the device such as ECHOSCAN (Do not press Enter).
2- Click on Library then Browse, locate the “echoscn2.dll” driver and
click on OK . The box marked “Echo Sounder” should have an “X”.
3- Move the cursor to “Update Frequency” and type in 135 ms (Do not
press Enter).
4- Click on Connect , select a Comm Port (normally 5) and configure for
19200 Baud, 8 bits, 1 stop, no parity, no flow control.
5- Click OK to return to the Devices Setup menu then click on Offsets .
6- Type in a Latency time of 135 ms and click on OK.
7- Click OK to close the Device Setup window.