OCULUS Corvis ST, Инструкция по эксплуатации, Страница: 58 / 86

14 Perform a mea s urement with the Corvi s ® ST unit
52 / 80 Instruction Manual Corvis® ST (G/72100/XXXX/EN 1019 Rev01)
14.3 Perform a Mea s urement
To prepare the measurement, proceed as described in sec. 11.1, page 23
and sec. 11.2, page 25 .
Perform the measurement as follows:

Select the measuring mode, sec. 14.3.1, page 52

Adjust the Corvis® ST, sec. 12.2, page 32

Start the measurement, sec. 12.3, page 37
14.3.1 Selecting a Mea s urement Mode
Depending on the version you can select the measurement mode.

Press this button.
Tono + P version

Press the [Tono/Pachy] button.
Tonometry and pachymetry are measured simultaneously.
Pachy version

Press the [Pachy] button.

The corneal thickness along the horizontal sectional plane is
measured but without the IOP.
14.4 Complete mea s urement
This button is displayed after a measurement has been conducted.

Press this button to save the examination data to the patient‘s
record.

After each patient remove one of the paper sheets from the chin rest.
See also
sec. 15.4, page 59 .

Disinfect the head rest and, if neccessary, the chin rest after each
patient,
sec. 15.2, page 58 .
Attention
Risk of infection after examining a sick patient
If you perform a measurement on a sick patient, the air nozzle and the
front cover can be contaminated.

Clean the air nozzle when you have examined a sick patient, see
“Clean the air nozzle (2)” page 57 .

Disinfect the front cover sec. 15.2, page 58 .