oConnor 2575D, Руководство оператора

Страница: 19 / 22

Operators Guide
18
Servicing
General
The 2575D pan and tilt head is robustly made to high engineering standards and little attention
is required to maintain serviceability except for regular cleaning.
For service beyond the maintenance items described below, contact the OConnor headquarters
or your local OConnor representative. Contact information is provided at the end of this
document.
Routine Maintenance
Replace the battery whenever the bubble level illumination is inadequate.
During normal use, check the following:
• Check the effectiveness of the pan and tilt locks. Reset as necessary - see Adjusting the
Lock Levers .
• Check the operation of the illumination of the bubble level. Replace the battery if necessary
- see
Battery Replacement .
No other routine maintenance is required.
Cleaning
During normal operation the only cleaning required is a periodic wipe down with a lint-free cloth.
Any dirt that accumulates during storage or periods of non-use may be removed with a semi-stiff
brush. Particular attention should be paid to the dovetail faces of the camera mounting area.
Use out-of-doors under adverse conditions may require special attention and the head should
be covered when not in use. Salt spray should be washed off using fresh water at the earliest
opportunity. Sand and dirt act as an abrasive and should be removed using a semi-stiff brush or
a vacuum cleaner.
Adjusting the Lock Levers
If the pan and/or tilt friction locks do not fully engage at the end of the lock lever travel, adjust
the lever position as follows:
1. Rotate the lock lever to the "locked" end of travel.
2. Use a 3/32" hex key to loosen the set screw in the lock lever.
3. Pull the lock lever off the hexagonal shaft, rotate it away from the "locked" end of travel by
one flat on the shaft and reinstall it.
4. Tighten the set screw.
NOTE: Use only detergent-based cleaners. DO NOT use solvent-based or oil-based
cleaners, abrasives or wire brushes to remove accumulations of dirt as these
will damage the protective surfaces.